Testing The Printer; Checking 'Site' Function; Intervals For Testing The System Function - Siemens FS720 Commissioning, Maintenance, Troubleshooting

23 Maintenance

Testing the printer

23.8
23.9
23.10
Function
Software
Detector lines:
C-NET
106
Building Technologies
Fire Safety
Testing the printer
1. Check the roll of paper in the printer and ensure that there are spare rolls
available.
2. Initiate the printer test and check the print-out for legibility and correct printing.
3. Check whether the events are correctly printed out.
You will find more information about the printer in document A6V10211076. See
chapter 'Applicable documents'.
See also
Applicable documents [

Checking 'Site' function

Test the functions of the 'Site' in the various test modes:
You will find information about testing a 'Site' in the chapter 'Testing' in document
A6V10211076. See chapter 'Applicable documents'.
See also
Applicable documents [

Intervals for testing the system function

'Self test' for the 'Detectors'
The 'Self test' is an automatic performance check for FD720 'Detectors'. The
function of the 'Detectors' must be checked regularly on site despite this.
Detector inspection
Annual visual check of all 'Detectors'.
Replace 'Detectors' that are badly soiled or mechanically damaged.
Function test
The following table shows the intervals recommended for the function check.
National specifications always take priority.
Activity
Check date and time.
Activate an 'Automatic detector' and a 'Manual call point' per 'Line'.
Activate all 'Manual call points'.
Trigger all automatic fire detectors.
Check all 'Detectors' for soiling and application.
Check the function of the input/output modules.
On each 'Line' check whether a short-circuit or open line triggers a
'Fault'.
Check the loop line function.
During short-circuit also check the separator function.
8]
8]
Interval
(years)
1
X
X
X
A6V10210416_f_en_--
2 5
X
X
X
X
14.01.2013