Copying From The Bypass Table In The Moving-Original Scan Mode - Ricoh FT8982 Operating Instructions Manual

COPYING FROM THE BYPASS TABLE IN THE MOVING-ORIGINAL SCAN MODE

COPYING FROM THE BYPASS TABLE IN THE
MOVING-ORIGINAL SCAN MODE
The following size can be set in the bypass table.
Metric version: 420 x 700 mm
When you use copy paper A2 or larger, use the A2 guide plate (accessory).
Otherwise, copies might not be stacked properly.
To avoid problems caused by curly copies, try turning over the paper in the
bypass table. If there is no improvement, change to copy paper with less curl.
The scanned original will exit from the computer form original entrance. Make
sure than there are no objects near the entrance to avoid damaging originals.
Regarding functions that cannot be used together with this function,
page 94.
Open the bypass table and pull
the extender out.
Adjust the guides to the paper
size, and insert the
Adjust the moving original scan
table guide to the original size.
At the same time, adjust the docu-
ment feeder original guide to the nar-
rowest original position (front) to
avoid damaging originals. For loca-
tion of the guide,
;
, A2
; copy paper.
see page 28.
; ; ;
, A3 , A4
see
55