Where To Put Your Copier - Ricoh FT8982 Operating Instructions Manual

WHERE TO PUT YOUR COPIER

Copier Environment
Your copier's location should be carefully chosen because environmental
conditions greatly affect its performance.
Optimum environmental conditions
Temperature: 10 - 30°C (50 - 86°F)
Humidity: 15 - 90%
A strong and level base.
The copier must be level within 5 mm, 0.2" both front to rear and left to right.
Make sure to locate this copier in a large well ventilated room that has an air
turnover of more than 30 m
Environments to avoid
Locations exposed to direct sunlight or strong light (more than 1,500 lux.)
Locations directly exposed to cool air from an air conditioner or heated air from
a heater. (Sudden temperature changes might cause condensation within the
copier.)
Places where the copier might be subjected to frequent strong vibration.
Dusty areas.
Areas with corrosive gases.
Places higher than 2,000 m, 6,500 ft above sea level.
Power Connection
Connect the copier to a power source meeting the specifications given on the
inside front cover of this manual.
Avoid multiwiring.
Make sure that the wall outlet is near the copier and easily accessible.
Make sure the plug is firmly inserted in the outlet.
Voltage must not fluctuate more than 10%.
Do not set anything on the power cord.
Always turn the copier off when you have finished copying for the day, but
leave it plugged in.
134
WHERE TO PUT YOUR COPIER
/hr/person.
3