Document Feeder - Ricoh FT8982 Operating Instructions Manual

DO'S AND DON'TS
When removing misfed paper
Since some parts of the copier are supplied with high electrical voltage, touch
only the parts specified in the instructions on the sticker inside the machine's
cover.
When removing misfed paper from sections H and I, use caution. The fusing
unit may be very hot.
Do not leave any torn scraps of paper in the machine.
When clearing misfeeds, do not turn off the main switch. If you do, your copy
settings are cleared.
After clearing misfeeds, make sure that all units and levers are returned to their
original positions and all covers are closed.
General operation
Do not touch the anticondensation
switch located inside the left front
door. This switch is used only by
your service representative.

Document Feeder

While originals are fed from the original table to the exposure glass, do not pull
out the originals.
Do not lift the document feeder until the last original has been completely fed
out.
Do not press down or hold originals after inserting them.
Do not press any parts of the document feeder strongly.
136
See page 4 for the position of the fusing unit.