Ricoh FT8982 Operating Instructions Manual page 75

Touch the [Edit Image] key.
Make sure that the [Save/Delete]
key is selected.
Touch the [Save Area] k e y.
Then, touch the [#] key.
Designate the area you want to save following the instructions on the
display.
To change the number entered:
Before touching the [#] key, press the Clear/Stop key. After touching the [#]
key, touch the key which number you want to change. Then, enter the new
number.
Set your originals on the exposure glass or in the document feeder.
Press the Start key.
Erasing part of original image (Delete Area)
When making copies after designating the area, set the original on the expo-
sure glass or in the document feeder as shown in the illustrations on page 66.
The designated line will vary by ± 5 mm or 0.2". Therefore, leave at least 5 mm
or 0.2" between the designated line and the image. If this clearance is narrower
than 5 mm or 0.2", an undesired area might be deleted or saved.
EDITING THE COPY IMAGE (Edit Image)
67