Fire Sense LIP-10A-TGG-LPG-SP Manual page 7

ASSEMBLY
7
Assemble Reflector Panels
come packaged in two brown boxes with two panels in each box. Hardware for
assembly is already affixed to each panel. Place two panels side by side and remove
the two cap nuts and washers that are affixed to one panel. Insert the affixed bolts
into the open holes on the adjacent panel. Place the washer over the bolt and screw
on cap nut. Repeat these steps until all four panels are assembled. Then locate the
Reflector Center Cap. You will need to remove the cap nuts and washers located at
the top of each Reflector Panel to allow assembly of the Center Cap on each panel.
Align the holes in the Center Cap with the bolts on each panel and affix washer and
cap nut to complete assembly.
8
While supporting heater, tilt the Head Assembly
Reflector over the 3 bolts that extend from the Head Assembly. Use the 3 M8
Wing Nuts and 3 M8 Washers
Q
Assembly of the heater. Once you have tightened the Wing Nuts, return the heater
to an upright position.
Hardware Used: 3x M8 Wing Nut
9
Connect the Gas Hose and Regulator to the LP cylinder. The LP cylinder is sold
separately. Use a standard 20 lb. propane cylinder only. Lift the Tank Housing
up and rest it on the top of the assembled Post Supports
onto Gas Hose . Do not cross-thread. Hand-tighten securely. Attach Regulator
E
to valve on LP cylinder and hand-tighten securely. Place LP tank onto base of
G
heater and secure LP Tank on base by hooking Tank Strap
. Lower the Tank Housing. NOTE: Use this heater only with a propane vapor
J
withdrawal supply system. See chapter 5 of the standard for storage and handling
of liquefied petroleum gas, ANSI/NFPA 58. Your local library or fire department
should have this book.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
with Reflector Center Cap
A
C
to secure the assembled Reflector to the Head
S
3x M8 Washer
. Reflector Panels
B
and slide the assembled
D
. Screw Regulator
J G
onto the Post Supports
I
B
A
7
Q S
8
E
G
G
9
9
A
B
A B
C
D
J
E
G
I
7