YASKAWA SI-EM3 Installation Manual page 34

5 Installation Procedure
Procedure C
n
This section shows the procedure to install and wire the option on a GA700 or GA800 drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive GA700, make sure that the option
software version is PRG: 8103 or later.
Before you install the option on a YASKAWA AC Drive GA800, make sure that the option
software version is PRG: 8104 or later.
1. Correctly wire the drive as specified by the manual packaged with the drive.
2. Make sure that the drive functions correctly.
Refer to Figure 18
components for reference in the installation procedure.
Figure 17
K
J
I
A – Insertion point for CN5 connector
B – SI-EM3 option
C – Included screws
D – Drive front cover
E – LED label
F – Keypad
G – Option modular connector CN1
H – LED Status Ring board
34
for an exploded view of the drive with the option and related
H
G
Figure 18 Drive Components with Option
YASKAWA ELECTRIC TOBP C730600 91D YASKAWA AC Drive Option SI-EM3 Installation Manual
A
B
C
I – Connector CN5-A
J – Connector CN5-B
(Not available for communication
option installation.)
K – Connector CN5-C
(Not available for communication
option installation.)
A1000
E
D
F