YASKAWA SI-EM3 Installation Manual page 26

5 Installation Procedure
6.
Firmly connect the Ethernet communication cable to the option modular connector
(CN1).
Install Modbus communications cables apart from main-circuit wiring and other
electrical and power lines. Ensure the cable end is firmly connected (see
Figure 24). Refer to
of installing.
7.
Reattach the drive front covers (C, F) and the keypad (D).
NOTICE: Do not pinch cables between the front covers and the drive. Failure to comply could cause
erroneous operation.
Figure 10
8.
Set drive parameters in
26
Communication Cable Specifications on page 40
Figure 10 Replace the Front Covers and Keypad
Table 6
YASKAWA ELECTRIC TOBP C730600 91D YASKAWA AC Drive Option SI-EM3 Installation Manual
for correct option performance.
for details
A1000
C
D
F