Table of Contents
Advertisement
Mounting
5.5 Withdrawing/inserting the CFast card
To insert the CFast card into the memory card slot again:
Push the CFast card into the memory card slot until it locks into place (ball-point pen
mechanism).
5.5.1
Automatic restart for SIMOTION P Runtime
Note
Not a Windows restart
Note that this is not a Windows restart!
Starting the SIMOTION P320-4 with withdrawn CFast card
Power-up of the SIMOTION P Runtime is not possible without the CFast card. A prompt
referring to the missing CFast card is displayed. The prompt is displayed until the CFast card
is inserted. The power-up is then continued and the prompt closed automatically.
The automatic restart of the SIMOTION P Runtime is performed when the Enabled checkbox
is activated in the SIMOTION P Control Manager in the Administration tab at Automatic Restart
By Plug-In External Memory Card.
Figure 5-4
Note
The prompt does not close automatically after inserting the CFast card.
If the prompt shown above is not automatically closed after inserting the CFast card and there
is no automatic restart of the SIMOTION P Runtime, check the BIOS settings.
See Section Hotplug Enabled BIOS settings (Page 203).
If the Disabled status has been selected in the SIMOTION P Control Manager, there is no
automatic restart of the SIMOTION P Runtime after the CFast card has been inserted. In this
case, the following prompt is displayed.
86
Prompt about the missing CFast card - automatic restart Enabled
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 11/2016
Advertisement
Table of Contents
