Table of Contents
Advertisement
im Vertrieb von
Picture-in-picture mode
Changing the input
Using the swap feature
www.camboard.de
CAMBOARD Electronics
The DVS 304 allows you to display two image sources on the screen
simultaneously. Keep in mind that when using the PIP feature, one image source
must be low-resolution (composite, S-video, YUVi and RGBcvS) video, while the
other must be high resolution (YUVp, RGB scaled) video. If these conditions are
not met (i.e., two low resolution video inputs or two high resolution inputs are
selected), the PIP mode will quit.
To go into Picture-in-picture mode, do the following:
1.
Select an input for the main window.
2.
Define the size of the main window before starting PIP mode.
For quick sizing setup, use the 16*
for the PIP window.
Activate the PIP mode via an SIS command or IR remote; specify the PIP
3.
window input.
DVS 304 checks the input format for the PIP window and returns an error
message if an invalid selection is made.
When the PIP mode is active, note the following:
•
The LED for the main window input is ON.
•
The parameters of the PIP window are adjustable from the front panel or
SIS commands only.
•
Any change in configuration (except positioning) of the PIP window is
saved to that input even after the PIP mode is not longer active.
•
The PIP window input is listed under the default cycle on front panel
menu, as shown below.
Default Cycle
INPUT 1
PIP WINDOW
2 sec.
COMPOSITE
INPUT 2
Figure 2-18 — The PIP sequence
If the PIP window source is out, the PIP mode exits until an active signal is
detected. When the main window source is removed, a black background
displayed.
To change the input for the PIP and/or main window, determine if the
corresponding input is a low or high resolution.
If your main window image is from a low resolution source, switch to another
low resolution input from the front panel. In this case, the PIP window retains
its high resolution.
Use the swap feature to switch the parameters between a main window and PIP
window on a display. This feature is available only through SIS commands or IR
remote.
For audio models (DVS 304 A or AD), you can allow audio to follow the main
(default) or PIP window. Audio breakaway is not possible while PIP mode is on;
audio must follow either the main window or the PIP window.
Tel. 07131 911201
Fax 07131 911203
# SIS command to set different sizes
X105
2 sec.
OUTPUT
2 sec.
1024 x 768@60
ce-info@camboard.de
DVS 304 • Installation and Operation
2- 19
Advertisement
Table of Contents
