Table of Contents
Advertisement
im Vertrieb von
Advanced configuration
IP
CONFIG
MENU
ADVANCED
CONFIG
Auto Image
Blue mode
www.camboard.de
CAMBOARD Electronics
To change an IP address, do the following:
1.
Press and hold the Input 4 and Next buttons simultaneously for 2 seconds.
This introduces the Setup mode.
2.
Change the flashing octet selection by using the Adjust vertical ( ) knob.
Change the selection numbers by using Adjust horizontal (
3.
Press the Menu button to return to the IP address setup and the Next button
to select another address setup.
4.
Press the Next button (after the Gateway mask menu) to exit.
The IP configuration menu "times out" if there is no activity for over 10 seconds.
The following flowchart provides an overview of the Advanced Configuration
submenus and the options for each setting.
AUTO IMAGE
NEXT
NEXT
<OFF>
ON
<OFF>
Auto imaging
When auto image is on,
the unit automatically
sizes and centers each
new input.
Figure 2-17— Advanced Configuration menu
When an image appears on the screen, the auto image feature consults a table of
default parameters to see how it should display.
When a new signal is detected and auto image is set to "On", the DVS 304
applies the default (sizing and centering) parameters for that signal's resolution
and frequency.
When a new signal is detected and auto image set to "Off", the DVS 304 first
searches the user memory table to find any user-defined parameters for that
signal resolution. If found, the user defined parameters are automatically
applied; otherwise, the DVS 304 applies the auto image feature as described
above.
The Blue mode assists the user in setting up a scaler's color and tint level. To use
this feature, set this submenu to "On" so that only sync and blue video signals
will be passed to the display.
Tel. 07131 911201
Fax 07131 911203
BLUE MODE
AUTO SWITCH
NEXT
<OFF>
ON
ON
Auto switching
Blue mode
The unit switches to the
When set to on, only the
highest numbered input,
sync and blue video
which as a signal present
signals are passed to the
when auto switching is on.
display
TEST PATTERN
NEXT
OFF
Test patterns
• Off
• Crop
• Alternating pixels
• Color bars
ce-info@camboard.de
DVS 304 • Installation and Operation
) knob.
RGB DELAY
NEXT
NEXT
0.0 sec.
RGB delay
Can be set from 0 to 5.0
seconds in 0.5 steps.
OSD LABEL
NEXT
2 sec.
OSD label duration
Can be set from 0 OFF
(no OSD) to 5 seconds in
1 second steps.
2- 17
Advertisement
Table of Contents
