Inspection, Maintenance, And Cleaning - Chicago Electric 95219 Assembly And Operation Instructions Manual

INSpECTION, MAINTENANCE, AND CLEANING

WARNING! Make sure the Stone Grinder is disconnected from its electrical outlet
1.
prior to performing any inspection, maintenance, or cleaning procedures.
before each use: Inspect the general condition of the Stone Grinder. Check for
2.
cracked or broken parts, damaged electrical wiring, damaged Abrasive Disc, and
any other condition that may affect safe operation. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Do not use damaged equipment.
SpINDLE
LOCK
(20)
To change Abrasive Disc (57): The Stone Grinder uses a 4" diameter Abrasive
3.
Disc. To change discs, press and hold the Spindle Lock (20) and rotate the disc
until it engages. Use the Double End Wrench (60) to loosen and remove the Disc
Nut (56). Remove the old Abrasive Disc and install a new Disc. While pressing
down on the Spindle Lock, use the Double End Wrench to tighten the Disc Nut.
(See figure G.)
4. To clean or replace the Carbon brushes (46): It may become necessary at
sometime to replace or clean
the two Carbon Brushes when
the Motor performance de-
creases, or stops working com-
pletely. The Carbon Brushes
are located within the Shroud
(39). (See figure H.)
a. Unscrew and remove the
Tap Screw (40) located at
the rear of the Shroud (39).
for technical questions, please call 1-800-444-3353
SKU 95219
DISC NuT
(56)
AbRASIVE DISC
(57)
fIGuRE G
Tap Tap
SCREW SCREW
(40) (40)
SHROuDS SHROuDS
(39) (39)
CARbON bRuSHES (46) CARbON bRuSHES (46)
CARbON bRuSH HOLDER (48) CARbON bRuSH HOLDER (48)
fIGuRE H fIGuRE H
PAGE 12
HOuSING HOuSING
(49) (49)