Maintenance And Servicing; Cleaning, Maintenance, And Lubrication - Chicago Electric 67648 Set Up And Operating Instructions Manual

MAintenAnce And
SerVicing
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FrOM AccidentAl
OperAtiOn:
turn the power Switch of the tool
off and unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
tO preVent SeriOuS injurY
FrOM tOOl FAilure:
do not use damaged equipment.
if abnormal noise or vibration
occurs, have the problem
corrected before further use.
cleaning, Maintenance, and
lubrication
1. beFOre eAch uSe,
general condition of the tool. Check for
loose screws, misalignment or binding of
moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation.
2. Periodically blow dust and grit out of
the motor vents using dry compressed
air. Always wear ANSI-approved safety
goggles and NIOSH-approved breathing
protection when performing this
maintenance operation.
3. AFter uSe,
of the tool with a clean cloth. Do not
use solvents or harsh cleaners as they
Page 16
tO preVent
SeriOuS injurY
inspect the
wipe external surfaces
For technical questions, please call 1-800-444-3353.
may damage the housing. To prevent
electrical shock, do not allow water or
other liquids to enter the motor vent
holes.
4. The grease in the gearbox will require
replacement after extensive use of the
grinder. Have the tool serviced by a
qualified technician for this procedure.
5. wArning! if the supply cord of
this power tool is damaged, it must be
replaced only by a qualified service
technician.
SKU 67648