Audio-Input Configure Selection - Extron electronics CrossPoint 300 Series User Manual

im Vertrieb von
Matrix Software, cont'd
Mute-Outputs settings — Displays the RGB Delay & Mute Adjust screen, from
Update firmware — Allows you to replace the firmware that is coded on the
Hardware status — Provides an overall view of the status of the matrix switcher,
Figure 5-6 — Status window
Name presets — Allows you to assign a name to each of the 16 memory presets.
Show RS-232 strings — Displays the ASCII commands that are used by the current
Initialize — Initializes and clears any or all of the following: ties, presets, audio

Audio-input Configure selection

Displays the audio gain level setting for a single input or for all inputs and allows
you to change it. The level is expressed as the magnitude (number of decibels) and
polarity (positive, gain or negative, attenuation) of the audio adjustment.
www.camboard.de
5-8 CrossPoint 300 Matrix Switchers • Matrix Software
CAMBOARD Electronics
which you can mute video and/or audio for each input.
switcher's control board without taking the switcher out of service, opening
the switcher enclosure, and replacing the firmware chip set. See Update
firmware on page 5-5.
including the power supply status and the individual voltages, the
temperature status, the Remote RS-232/RS-422 port configuration, and the
installed and updated firmware status (figure 5-6).
Preset names are limited to 12 upper- and lower-case alphanumeric characters
and the {space} + _ : = and / characters.
The following characters are invalid in preset names: ~ , @ = ' [ ] { } < >
' " ; : | \ and ?.
configuration. You can refer to these for RS-232/RS-422 programming.
configuration, preset titles, I/O names, and I/O icons.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de