Sync Termination Switches (Systems With Sync Bmes); Audio Input And Output (Systems With Audio Bmes) - Extron electronics CrossPoint 450 Plus Series User Manual

Sync termination switches (systems with sync BMEs)

c
Sync termination switches — The CrossPoint 450 Plus sync
matrix switcher BMEs have sync termination switches on
the rear panel for inputs 1 through 16. The switches provide
a way to condition non-TTL sync levels greater than 5 Vp-p,
enabling the sync to be properly passed from input to
selected output(s).
Each switch provides the option of selecting either 510 ohms
or 75 ohms. The 75 ohms position is required only for
an input with non-TTL sync, greater than 5 V p-p. The normal position is
510 ohms.
N An input that produces an out of sync display (a display that is rolling
vertically, tearing horizontally, or both) could indicate a non-TTL sync input.
A device that is known to output non-TTL sync levels (greater than 5 V p-p)
should be connected to one of the inputs with sync termination switches, and the
switches for that input should be set to the 75 ohm position. If you are not sure,
check the specifications in the user's manual for the input device.

Audio input and output (systems with audio BMEs)

N Figure 2-2 shows a MAV Plus 6464 stereo audio BME. The mono audio BME
looks similar, but has 3-pole captive screw connectors rather than the 5-pole
connectors shown.
By default, the audio ties follow the video ties. Audio breakaway, which can be
activated via the optional front panel or under Ethernet or RS-232/RS-422 control,
allows you to select from any one of the audio input sources and route it separately
from its corresponding video source. See chapter 3, "Operation", chapter 4,
"Programmer's Guide", chapter 5, "Matrix Software", and chapter 6, "HTML
Operation", for details.
d
Connections for balanced and unbalanced audio inputs — Each input has a
3.5 mm, 5-pole (stereo audio BME) or 3-pole (mono audio BME) captive screw
connector for balanced or unbalanced stereo or mono audio input (depending
on the BME). Connectors are included with each switcher, but you must
supply the audio cable.
See figure 2-3 to wire a connector on a stereo audio BME for the appropriate
input type and impedance level.
Do not tin the wires!
Figure 2-3 — Captive screw connector wiring for stereo audio inputs
See figure 2-4 to wire a connector on a mono audio BME.
Do not tin the wires!
Figure 2-4 — Captive screw connector wiring for mono audio inputs
CrossPoint 450 Plus and MAV Plus Switchers • Installation
Tip
Sleeve
Sleeve (s)
Tip
Sleeve
Unbalanced Stereo Input
Tip
Ring
Sleeves
1 2 3 4 5 6 7 8
75
510
10 12 14 16
9 11 13 15
75
510
Tip
Ring
Tip
Ring
Balanced Stereo Input
2-5