Extron electronics CrossPoint 300 Series User Manual page 4

im Vertrieb von
Quick Start — CrossPoint 300 Matrix Switchers, cont'd
RGBHV and Audio buttons select/deselect
video and/or audio. The Audio LED blinks to
indicate audio breakaway.
The Audio button and LED are present on
video-only switchers, but have no function.
Audio also selects the audio level/adjust
mode. See View, adjust the audio level.
Create a tie
1. Press and release the Esc
button to clear any input
LEDs, output LEDs, or
control LEDs that may be lit.
2. Press and release the
RGBHV and/or Audio I/O
button(s) to select or
deselect video and/or audio as desired.
Lit when selected.
Off when deselected.
RGBHV AUDIO
3. Press and release the
desired input button.
4. Press and release the
desired output button(s).
Output LEDs blink to indicate a potential tie.
3 4
Enter LED blinks to indicate the
need to confirm the change.
5. Press and release the Enter button. All input
and output LEDs and the Enter LED go out.
www.camboard.de
QS-2
CAMBOARD Electronics
Press the Esc button
to clear all selections.
ESC
The LED blinks once.
I/O
Lit when selected.
Off when deselected.
5
The input LED
lights to indicate
the selection.
8 ENTER
Tel. 07131 911201
Fax 07131 911203
Save or recall a preset
1. Save a preset — Press and hold the Preset
button for 2 seconds.
Recall a preset — Press and release the Preset
button.
Save a
Press and hold.
preset
2 seconds
PRESET
Preset LED blinks.
Recall a
Press and release.
preset
PRESET Preset LED lights.
All input and output buttons with assigned presets light.
The configuration data at assigned preset
locations will be overwritten.
1 2 3
2. Press and
1
The LED blinks to indicate that this preset
release the
is selected.
desired
input or
output
button.
3. Press and release the Enter button.
View, adjust the audio level
1. Press and hold the
Audio button.
2. Press an input or
output button. See
AUDIO
chapter 3 to read the
displayed value.
5
Press an input button to adjust gain/attenuation.
— or —
Press an output button to adjust the output volume.
1 2 3 4
3. Increase and decrease the gain/attenuation or
volume level by
button
pressing the
decreases
Esc ( ) and
the level.
View ( ) buttons.
4. Press and release the
Audio button to exit.
ce-info@camboard.de
PRESET
PRESET
4 5
The Enter LED
blinks to indicate
the need to save or
ENTER
recall the preset.
Audio LED blinks.
Hold
2 seconds
AUDIO
Output LEDs display
gain/attenuation.
— or —
Input LEDs display
output volume level.
OUTPUTS
button
increases
the level.
VIEW ESC