Table of Contents
Advertisement
DURADRIVE Drive Controllers
8.2
General notes
General notes
DOK-DURADR-HDC01.1****-PR02-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Electrostatic discharge from persons and/or tools can damage the
controller or printed circuits boards (PCB's). Please note the following:
Damage to electronic components and
interference with their safety of operation
caused by electrostatic charges!
⇒ Objects coming into contact with components and
CAUTION
circuit boards must be discharged by means of
grounding.
triggering motors and moving elements.
Such objects can be:
• The soldering iron when soldering
• The human body (ground by touching a conductive, grounded object).
• Parts and tools (place on conductive surface)
Parts at risk may only be stored and shipped in conductive packaging.
Note:
The diagrams of Rexroth Indramat should only be used by a
Machine Manufacturer to create terminal diagrams for a
facility. When wiring a facility, an End user should only use the
diagrams of the Machine Manufacturer.
• Route signal lines separately from load lines to avoid interference.
• Conduct analog signals (e.g., command/actual values) via shielded
leads.
• Mains, DC bus and power lines should not be connected to low
voltages or come into contact with them.
• When conducting a high voltage test or external voltage capacity test
of the electrical components of the machine, disconnect or remove all
connections of the units. This protects the electronic components
(allowed as per EN 60204-1). Rexroth Indramat drive components are
high-voltage and insulation tested as per EN 50178.
Potential damage of the controller device by
connecting and disconnecting the connections
with mains power on.
⇒ Do not connect and disconnect connections if the
CAUTION
mains power is on.
Constructing the control cabinet
Otherwise
errors
may
8-7
occur
when
Advertisement
Table of Contents
