Pego ECP200 BASE 4A Use Manual page 8

E. BOARD ECP200 BASE 4/4A
To access the second programming level press the UP () and DOWN () keys and the
LIGHT key simultaneously for a few seconds.
When the first programming variable appears the system automatically goes to stand-by.
1. Select the variable to be modified by pressing the UP () and DOWN () keys. When
the parameter has been selected it is possible to:
2. View the setting by pressing the SET key.
3. Modify the setting by holding the SET key down and pressing the () or () key.
4. When configuration settings have been completed you can exit the menu by pressing
the () and () keys simultaneously and keeping them pressed until the room
temperature reappears.
5. Changes are saved automatically when you exit the configuration menu.
6. Press the STAND-BY key to enable electronic control.
VARIABLES
AC Door switch status (with door closed)
F3 Fan status with compressor off
F4 Fan pause during defrost
Sensor presence
If the evaporator sensor is disabled
defrosts are carried out cyclically with
dE
period d0: defrosting ends when an
external device trips and closes the remote
defrost contact or when time d3 expires.
Defrost type, cycle inversion (hot gas) or
d1
with heater elements
Net address for connection to T
Ad
supervision system or Modbus
Minimum and maximum temperature
Ald
signalling and alarm display delay
Minimum time between shutdown and
subsequent switching on of the
C1
compressor.
CAL Cold room sensor value correction
Page 8
LEVEL 2 PROGRAMMING (Installer level)
LIST OF LEVEL 2 VARIABLES (Installer level)
MEANING
USE MANUAL
CHAP. 2 - Parameter programming
0 = normally open
1 = normally closed
0 = Fans run continuously
1 = Fans only run when
compressor is working
0 = Fans run during defrost
1 = Fans do not run during
defrost
0 = evaporator sensor present
1 = no evaporator sensor
1 = hot gas
0 = element
0 ÷ 31 (with AU=3)
eleNET
1 ÷ 247 (with AU=7)
1...240 min
0...15 min
-10...+10
VALUES DEFAULT
Rev. 02-18
2.9
2.10
0
1
1
0
0
0
120 min
0 min
0