E. BOARD ECP200 BASE 4/4A
To enhance safety and simplify the operator's work, the ECP200 BASE has two
programming levels; the first level (Level 1) is used to configure the frequently-modified
SETPOINT parameters. The second programming level (Level 2) is for general parameter
programming of the various controller work modes.
It is not possible to access the Level 2 programming directly from Level 1: you must exit
the programming mode first.
For purposes of practicality the following symbols are used:
• () the UP key
• () the DOWN key
1. Press the SET key to display the current SETPOINT (temperature).
2. Hold down the SET key and press the () or () keys to modify the SETPOINT.
Release the SET key to return to cold room temperature display: the new setting will be
saved automatically.
Page 6
GENERAL
KEY TO SYMBOLS
is used to increase values and mute the alarm.
is used to decrease values and force defrosting.
SETTING AND DISPLAYING THE SET POINTS
USE MANUAL
CHAP. 2 - Parameter programming
Rev. 02-18
2.4
2.5
2.6