Nice AVIO600 Instructions And Warnings For Installation And Use page 46

82
Photocell
Internal photocell h= 50 cm;
A
activated when closing
Internal photocell h= 100 cm;
B
activated when closing
External photocell h= 50 cm;
C
activated when closing and
opening
External photocell h= 100 cm;
D
activated when closing and
opening
WARNING: in the AVIO600 version the BUS output has a maximum load of 1 unit (with A type addresses only).
in the AVIO1000 version it has a maximum load of 6 units; a pair of photocells absorbs power equal to 1 ECSBUS unit.
• Mode 1: in this "mode" the radio transmitter is used to its fullest extent,
i.e. all the buttons execute a pre-established command. It is obvious that
in Mode 1 a radio transmitter can be used to command a single automa-
tion, i.e.:
Button T1 "Step-by-Step" command
Button T2 "Open partially" command
Button T3 "Open only" command
Button T4 "Close only" command
• Mode 2: one of the four commands available can be associated to
each button. This mode, used properly, allows you to command 2 or
more different automations; for example:
Button T1 "Open only" command automation N° 1
Button T2 "Close only" command automation N° 1
Button T3 "Step-by-Step" command automation N° 2
Button T4 "Step-by-Step" command automation N° 3
Obviously, each transmitter is a separate unit, and while some are memo-
rised in mode 1 others can be memorised in mode 2 on the control unit.
The overall memory capacity is 150 units; memorisation in mode 1 takes
up one unit for each transmitter while mode 2 takes up one unit for each
button.
Warning: since the memorisation procedures are timed (10s), you
must read the instructions in the following paragraphs before you
proceed with their execution.
83
TABLE 12
Jumpers Photocell
E
F
G
5.4.1 – Memorisation mode 1
1 Press button P1 [A] for at least 3s.
84
When the P1 LED [B] illuminates, release the button.
2 Within 10s, press any button on the radio transmitter to be memorised
and hold it down for at least 3s.
If the memorisation procedure is successful, the P1 LED
times.
3 If there are other transmitters to be memorised, repeat step 2 within the
next 10s, otherwise the memorisation stage will terminate automatically.
5.4.2 – Memorisation mode 2
With the memorisation in mode 2 of the radio transmitter, any one of
the four commands ("Step-by-Step", "Partial opening", "Open only" and
"Close only") can be associated to each button.
In Mode 2 each button requires a separate memorisation stage.
1 Press button P1 [A] (figure 84) on the control unit as many times as the
number corresponding to the desired command, according to the follow-
ing table:
Once
Twice
3 times
4 times
External photocell activated
when opening
Internal photocell activated
when opening
INADMISSIBLE
CONFIGURATION
B
"Step-by-Step" command
"Open partially" command"
"Open only" command
"Close only" command
Jumpers
A
ill ash 3
English – 19