Nice AVIO600 Instructions And Warnings For Installation And Use page 30

2
a b
e f
2.3.1 – GD102 and GD103 Electromechanical Gearmotor
GD102 and GD103 are electromechanical gearmotors made up of a
24Vdc motor. They feature a mechanical release mechanism with cord
that allows you to move the door manually in the event of a power failure.
The gearmotor is fixed to the ceiling
The PR100 buffer battery can be used on the AVIO1000 version, which
allows some manoeuvres in the absence of the mains power supply.
The control unit actuates the gearmotor and provides for the control of the
supply of the different components; it features an electronic board with
incorporated radio receiver.
The control unit can actuate the gearmotor with two speeds: "slow" or
"fast".
Fig. 3:
The three P1, P2 and P3 buttons [B] and the corresponding LEDs are
used to program the control unit.
The yellow button [C] allows the door to be controlled during testing. The
same key will also be operated during daily use, through the incorporated
orange button [D].
To facilitate the electrical connections there are separate terminals for
each device [A], which are removable and colour-coded based on the
function performed. Next to each input terminal there is a LED that signals
its status.
The connection to the power supply is very easy: just insert the plug in a
power outlet.
TABLE 3
List of small parts
M6 self-tapping nuts
M6 x14 screws
6,3x38 tcei screws
g
ith the relative mounting brackets.
GD102 GD103
Pcs 2 Pcs 4
Pcs 2 Pcs 4
Pcs 4 Pcs 4
c
h
3
C
B
2.3.2 – PH200 photocells (optional)
The pair of PH200 wall-mounted photocells, once they are connected to
the control unit, enables the detection of obstacles found on the optical
axis between the transmitter (TX) and the receiver (RX).
TABLE 4
List of small parts for PH200
HI LO 4X9,5 screw
3,5X25 self-tapping screw
s 5 c nylon screw anchor
4
d
D
A
Q.ty
Pcs 4
Pcs 4
Pcs 4
English – 3