How To Assemble Machine - OREC AHRC 663 Operating Instructions Manual

How to Assemble Machine

1. Packaged product should resemble
picture at left. Please ensure that wires
are properly fitted and be careful not to
damage wires during assembly of
machine.
2. The bolts and pin in picture at left
should be tightened with a 17mm
wrench.
3. First set the handlebar as in the picture
at left. The notch on the deck should
be fitted into one of the bottom 3 holes
of the handlebar. The last hole should
not be used as this will place the wires
too close to the radiator, causing a fire
hazard.
4. Place the pin through the fitting at the
base of the handlebar and, using two
17mm wrenches, tighten the bolts as
shown at left.
14