OREC AHRC 663 Operating Instructions Manual page 16

Brake Wire runs
Brake wire comes out
parallel to the
from handlebar
handlebar (ok)
(danger)
5. Please ensure that the brake wire is
fitted beneath the handlebars (as
shown in picture on far left). If the
brake wire comes out from the
handlebars, there will be too much
stress on the drive belt when the clutch
is released.
6. Tools Included:
a. One (1) 10x12mm Double
Ended Wrench
b. One (1) 14x17mm Double
Ended Wrench
c. One (1) Pair Anti Fog Safety
Goggles
d. Four (4) Axle Pins
Note: When replacing axle pins,
please use only pins supplied by
OREC for use on the AHRC663.
These are specially designed pins that protect
the transmission if the machine comes in
contact with solid objects like metal or
concrete. Use of other pins may cause serious
damage to the transmission in these cases.
15