Humminbird MEGA 360 IMAGING Series Installation Manual page 8

NOTE: MEGA 360 Imaging can be shared with all SOLIX, HELIX G3N, and HELIX G2N
models over Ethernet.
Transducers: The MEGA 360 Imaging transducer is compatible with the following
transducers:
• HW Dual Spectrum
• HW MEGA DI+
• HW MEGA DI+/MEGA SI+
• Built-in MEGA Imaging transducer on a Minn Kota trolling motor
Cables: Your MEGA 360 Imaging transducer comes with the cables required to
connect directly to your Humminbird fish finder. This includes a 10' MEGA 360 power
cable, a 10' SOLIX transducer cable, and a 10' HELIX transducer adapter cable.
However, depending on your Humminbird model and system configuration, you may
choose to purchase a transducer splitter cable (y-cable) to connect the MEGA 360 to
another compatible transducer, as shown below.
MEGA 360 compatible transducer
splitter cables (y-cables)
MEGA 360 7-pin Transducer Y-cable:
9 M360 2DDI Y (720107-1)
MEGA 360 14-pin Transducer Y-cable:
14 M360 2DDI Y (720108-1)
* If this cable is being used with a HELIX G3N with MEGA Side or Down Imaging+ and a
Built-in MEGA imaging transducer, then the 720109-1 AD HELIX M360 adapter (included
with the MEGA 360) must be attached between this y-cable and the HELIX unit.
NOTE: If a MEGA SI+ transducer is connected with one of these y-cables, the
Humminbird unit will not be able to get SI data from the MEGA SI+ transducer – only HW
and MEGA DI+ will be available. However, the user can get MEGA SI data from the MEGA
360 transducer.
Introduction
MEGA 360 compatible transducers
HELIX Dual Spectrum (Type 9 / 7-pin)
HELIX MDI+ (Type 9 / 7-pin)
HELIX MDI+/MSI+ (Type 9 / 7-pin)
SOLIX Dual Spectrum
SOLIX MDI+
SOLIX MDI+/MSI+
Built-in MEGA Imaging*
2