Humminbird MEGA 360 IMAGING Series Installation Manual page 32

3. SOLIX: Insert the other end of the transducer cable to the sonar port on the control
head. Hand-tighten the screw nut.
HELIX: Insert the transducer adapter cable to the transducer port on the HELIX
control head.
4. Power: Route the power cable to the main switch or fuse panel (usually located
near the console). If you must connect to a battery, connect to a battery switch
(not included).
Cable Installation
SOLIX Sonar-Temp Port
HELIX 7 Control Head Ports
Ethernet power
(communications) transducer
HELIX 8, 9, 10, 12 Cable Tray
transducer
Ethernet
pin
COM
COM
(communications)
temp/speed
26
power
pin