Humminbird MEGA 360 IMAGING Series Installation Manual page 23

Install the Collar Clamp
After you have established the pod height is no closer than 1 inch from the tip
of the propeller, install the collar clamp to prevent the trolling motor from hitting
the transducer pod.
1. Apply anti-seize to the end of each 1" socket bolt (1/4-20 x 1").
2. Install a 1" socket bolt (1/4-20 x 1") into the hole on 1 clamp half.
3. Place the bumper into the groove of the trolling motor shaft. Center one
clamp half over the bumper as shown in the illustration.
4. Install a washer, the clamp (half), and hex nut (1/4-20) onto the trolling
motor shaft as shown in the illustration. Repeat on the other side.
nut
NOTE: If your installation kit does not include a washer, you may skip the
washer portion of the installation.
Installing the Collar Clamp
bumper
clamp
groove in trolling
motor shaft
socket bolt
(1/4 - 20 x 1")
clamp
washer
17 Trolling Motor Bracket