Transducer Maintenance
Use the following information to maintain the transducer operation.
• If your boat remains in the water for long periods of time, algae and other
marine growth can reduce the effectiveness of the transducer. Periodically
clean the face of the transducer with a cloth dampened with fresh water.
• If your boat remains out of the water for a long period of time, it may take
some time to wet the transducer when it is returned to the water. Small air
bubbles can climb to the surface of the transducer and interfere with proper
operation. These bubbles dissipate with time, or you can wipe the face of the
transducer with your fingers after the transducer is in the water.
MEGA 360 Imaging Maintenance
Use the following information to maintain the installation of the MEGA 360 Imaging
Transducer.
• Check the stability of the trolling motor bracket after initial use and periodically
thereafter to ensure that the installation and lock remain stable.
• If your boat will be in long-term storage, remove the MEGA 360 Imaging pod
shaft from the bracket and store it in –40°F to 158°F (–40°C to 70°C), dry
conditions.
37
Maintenance