Humminbird MEGA 360 IMAGING Series Installation Manual page 24

5. Use an Allen wrench (not included) to tighten the hardware just enough to
keep the collar assembled.
6. Slide the collar up to the base of the BowGuard.
7. Use an Allen wrench (not included) to fully tighten the socket bolts until
they are secure. Hand-tighten only!
Details: Tighten the socket bolts and collar clamp hardware evenly on both
sides of the clamp until you feel them start to compress and secure, and
then tighten each bolt an additional 1/4 to 1/2 turn.
WARNING! The socket bolts must be tightened completely to prevent the trolling
motor from potentially damaging the pod. Hand-tighten only!
Trolling Motor Bracket 18