Install The Trolling Motor Bracket; Ultrex Trolling Motor Mount (Mega 360 Ultrex) - Humminbird MEGA 360 IMAGING Series Installation Manual

2. Install the Trolling Motor Bracket

Proceed to the installation section of the type of trolling motor bracket you
purchased:
A. Ultrex Trolling Motor Mount (MEGA 360 Ultrex)
OR
B. Fortrex/Maxxum Trolling Motor Mount (MEGA 360 Fortrex)
A. Ultrex Trolling Motor Mount (MEGA 360 Ultrex)
WARNING! Disconnect the motor from all sources of electrical power before you
start installation.
WARNING! Confirm that the trolling motor is properly secured to the boat and will
not shift during the installation.
Assemble the Bracket
1. The trolling motor should be in the fully retracted (flat) position on the boat
deck for this installation.
2. Disconnect the motor from all sources of electrical power.
3. In addition to the requirements listed in the Prepare for Installation section,
determine if the bracket will be installed on the left or right side of the
trolling motor, so the transducer pod is mounted outboard of the trolling
motor and on the centerline of the boat. Determine the mount position from
the bow, facing the (forward) direction of travel.
If the trolling motor deploys starboard side (right) on the bow, you will
mount the bracket on the left side of the trolling motor. Position the bracket
so the straight edge faces to the left as shown in the illustration.
9 Trolling Motor Bracket