Humminbird MEGA 360 IMAGING Series Installation Manual page 20

Adjust the Pod Height
1. Deploy the Trolling Motor.
2. Loosen the socket bolts on the bracket where the pod shaft is installed. Adjust
the pod shaft up or down, so it meets the following height requirements:
• The pod must be mounted approximately 6" (152.4 mm) below the
waterline.
• The pod must be mounted at least 1" (25.4 mm) off the tip of the propeller.
• The pod shaft needs to protrude at least 1" to 2" (25.4 mm to 50.8 mm)
above the bracket when it is installed.
Trolling Motor Bracket 14