Humminbird MEGA 360 IMAGING Series Installation Manual page 18

Install the Bracket
As determined in the Assemble the Bracket section, the bracket can be mounted
on the left or right side of the trolling motor.
1. Align the plate below the BowGuard. Line up the holes on the plate with the
threaded holes on the BowGuard.
2. Install the (4) 5/16-18 x 1" screws through the plate and into the BowGuard.
Hand-tighten using a 5/16 nut driver until secure (see the illustration
Installing the Bracket ). Hand-tighten only!
BowGuard
plate
1" screw
(5/16 - 18 x 1")
Trolling Motor Bracket
Installing the Bracket
12