Humminbird MEGA 360 IMAGING Series Installation Manual page 30

11. Install the large insert into the slotted side of the clamp. Use a Phillips
screwdriver to install the #8-1/2" screw through the clamp and large insert
(see the illustration Installing the Inserts).
12. Install the small insert into the solid side of the clamp. Hold it in place, and re-
install the clamp and Depth Collar Knob. Make sure the clamp notch is facing
down and fits onto the collar node (see the illustrations Installing the Inserts
and Re-installing the Depth Collar Knob).
13. Fully hand-tighten the Depth Collar Knob.
WARNING! The Depth Collar knob must be tightened fully to prevent the
bracket from rotating and potentially damaging the pod. Hand-tighten only!
Installing the Inserts
small insert
large insert
with hole
depth collar knob
Trolling Motor Bracket
notch
#8 x 1/2" screw
Re-installing the Depth Collar Knob
24
depth
collar clamp