Programming - Teledyne 6600 Operating Instructions Manual

3 Operation
Anlz indicates that the analyzer is in the Analyze mode. If there is an * before
the Anlz, it indicates that the range is linearized.
If the concentration detected is overrange, the first line of the display blinks
continuously.
3.8

Programming

CAUTION: The programming functions of the Set Range and
Curve Algorithm screens are configured at the facto-
ry to the users application specification. These func-
tions should only be reprogrammed by trained,
qualified personnel.
To program, you must:
1. Enter the password, if you are using the analyzer's password
protection capability.
2. Connect a computer or computer terminal capable of sending an
RS-232 signal to the analyzer RS-232 connector. (See chapter 2
Installation for details). Send the rp command to the analyzer.
3. Enter the System menu.
Use the UP/DOWN switch to blink MORE, then Enter.
Select MORE and ENTER one more time
Now you will be able to select the APPLICATION and ALGORITHM
set-up functions.
3-28 Part I
1.95 ppm SO2
R1:Ø —10 *Anlz
DIG_FILT SELF-TEST
PWD LOGOUT MORE
AUTOCAL HMGNZR
CAL-HOLD-TIMER
ALGORITHM
MODEL OUTPUT:
Teledyne Analytical Instruments
HOLD
MORE
APPLICATION
4MA
Model 6600