Saab 95 1967 Service Manual page 538

REMUV'"
Before starting work, make sure that the car is thor-
1.
oughly deemed under the fenders. Scrape off all dirt
that might loosen and enter the bearings.
2' RemOVe the hub cap and
3. When the rear hub is involved,
followed by the cotter pin, the castle nut and the
washer.
4, Jack up the front or rear
ate .
5. Take off the wheel.
6' H dealing With the rear Wheel
handbrake is released and back off the brake adjust-
ing bolts. Remove the brake housing and
the wheel housing in such
not be damaged. Remove
and washer. Apply the hub puller — and secure it with
the ordinary wheels bolts.
HUB
FULLER, 78 40 028
7. Pull Off the hub.
8. Prevent sand and other foreign matter from ante
the hub seals and bearings by 0°"er these items
over with clean clothes.
back off the wheel bolts.
remove the dust cap
part of the car, as appropri.
hub, check that the
hang it on
a way that the brake hose
the cotter pin, crown nut
ring
INSTALLATION
Clean the hub thoroughly and make sure that there is no
dirt in the shaft seal.
1- Bafore installing, grease the tongue and
of the shaft seal.
Fit the hub on the shaft.
en the castle nut
18 kpm) for the front hub and 90
kW") for the rear hub, on front wheel hubs: refit the
brake housing.
. Secure the castle
wheel and the hub cap.
REPLACEMENT OF BALL BEARING IN REAR WHEEL
HUB
Changing the front wheel bearings, see group 6.
REMOVAL
Before starting work, make sure that the car
cleaned under the fenders.
loosen and enter the bearings.
1. Jack up the car
2. Remove the dust cap,
Remove the cotter pin, castle
$ 9 3 9 1 . 5 9 )
Check that the
Pull off the brake drum,
Remove the shaft seal
From outside the brake drum,
INSTALLATION
Clean all the components thoroughly, and
parts in place of any worn or damaged ones.
shaft seal.
om
sliding
Put on the washer and tight-
using a torque of 180 Nm
Nm (68 ft.-lb., 9.0
nut with the cotter pin. Refit
is thoroughly
Scrape off all dirt that
and remove the wheel.
using a screwdriver.
nut and washer.
handbrake is fully released.
using puller 78 40
and the circlip.
press out both
provide
surface
(130 ft.-|b.,
the
might
028.
bearings.
new
Fit 3 new
774~3