Model - Saab 95 1967 Service Manual

Alignment towards a screen
The various lines on the screen
""9 Of the car 1. the vertical
lights 2—2, and the horizontal center lines of the head-
lights 3—3.

1.

Check the tire pressure and
normally be loaded.
2. Up to and incl.

model

1973:
so that the adjusting screws
25 ft. (7.6 m) from the screen.
3. Switch on the high beam end
a time.
4. Check and adjust the headlight so that the beams come
2 in. (50 mm) under the
3—3. The tolerance limits which
by the center of the beam under any circumstances are
marked by the black area on the screen.
sal limits are 6 in. (150
2—2, and vertically the center of the beam may not be
above line 3—3 or more than
line 3—3.
ALIGNMENT OF SEALED BEAM
1. Center line of car
2—2. Vertical center line of headlight
3—3. Horizontal center line of
A = 2 in. (50 mm)
B = 6 in. (150 mm)
C = 10.5116 in. (415 mm)
351—4
correspond to: the center
center lines of the two head-
load the car as it would
Remove the trim frame
are accessible. Put the car
shield one headlight at
intersections of lines 2—2 and
may not be exceeded
The transver-
mm) to the right or left of line
4 in. (100 mm) below
III! VII/I4 'II II. 'IIIIIIIII.
{5227/
UNITS
headlight
5, Check both hemt gar
symmetric. If
rect setting, fit
6. If the high beams ar
necessary to adjust t
SAAB
and make sure that the beam is
adli hts .
if it proves difficult
w Sealed Beam unit.
a ne
e correctly aligned it
he dipped beams separately.
to get a cor-
will not be