Model - Saab 95 1967 Service Manual

ASSEMBLY
RE
Before reassembling the master cylinder, dip all
brake fluid.
Locate the cups on the

1.

are correctly positioned,
FITTING THE PISTON WASHER
12. Primary cup
13. Piston washer (dished)
14. Secondary piston
2. Install the spring (18)
together so that the retaining pin (19) can be installed.
3. Fit the pistons in the cylinder.
that the gaskets not be damaged.
4. Install the piston stop
5. Mount spiral clip (24)
78 41 992.
6. Install the washer
the nylon bearing
7. Install spring (9) and spring retainer
mary piston
8. Compress the retain spring
clip
9. Lubricate the small end of the push
silicon grease and install the rubber bellows
retainer
10. Screw on the outlet adapters and
Tighten to 38 Nm (28 ft.-Ib., 3.8 kpm).
11. Install the cover 5 and tighten the screws to 7
(6 ft.-Ib., 0.7 kpm).
INSTALLATION
1. Cover all openings to prevent the entry of foreign
ter into the cylinder during
2. Attach the brake cylinder.
3. Refit the rubber boot to the push
push rod if it has been disassembled.
4. Reconnect the outlet brake
with brake fluid.
Adjust the brake pedal free
524.
Bleed the system. See section
Cabs. (I'l'l
parts in
pistons and check that they
see fig.
on the pistons and press them
NOTE! Be carefull
with the aid of tool
the secondary cup (26) and
Lock with spiral clip
(30) on the pri-
(9) and install the spiral
rod (31) with
(11) with
non return valves.
Nm
mat-
the installation work.
rod. Reassemble the
lines and refill the system
movement. See section
520.
As from model
If it is necessary to dismantle the
part thereof, this must be done
pulous cleanliness. See section 520.
REMOVAL AND
INDER WITH VACUUM SERVO
1. Remove the protective cover of the steering wheel
shaft.
2. Loosen the screw joints of the outlet
the master cylinder.
from the vacuum
9"
Detach the push
4. Loosen the four nuts
the dash panel.
the car. Remove the master cylinder.
The installation is
REMOVAL AND
INDER
so When removing and
not necessary to remove
1. Loosen the screw joints of the outlet brake
the master cylinder.
2. Remove the two
to the vacuum
3. Remove the master cylinder.
The installation is made
Bleeding the brake system, see section 520.
1969
brake system,
under conditions of scru-
INSTALLATION OF MASTER
brake
Disconnect the vacuum
servo.
rod at the brake pedal.
retaining the vacuum
The nuts are accessible from
made in the reverse order.
INSTALLATION OF MASTER
installing the master cylinder,
the vacuum servo.
nuts retaining the master cylinder
servo.
in the reverse order.
or any
CYL-
lines at
hose
servo to
inside
CYL-
it is
lines at