Model - Saab 95 1967 Service Manual

REMOVAL, INSTALLATION
REMOVAL
If work is to be done on the transmission
entire power unit must be lifted out. The engine is then
separated from the transmission unit.

1,

Disconnect the battery
2, Remove the hood by
moving the locking springs for the hood hinges. Dis-
connect the hose for the windshield washer.
grip the hinge stay. bending it slightly inwards to re-
lease the pin on one
hood on the other side and
REMOVAL OF ENGINE HOOD
Remove the windshield
washer pump.
3. Drain off the cooling water through the
draining tap. To ensure that draining will be as ef-
fective as possible, bleed the system through
bleed nipple on the heat
ant.
Up to and incl. model 1968
4. Disconnect the headlight and
cables.
5. Back off the four screws for the front panel and de-
tach the two radiator supports from
Detach the clamping straps from the radiator and
remove the hood lock and control wire.

Model

1969—1970
4- Remove the headlight decor frames.
headlight cables.
5- Back off the four screws for the front panel and de-
tach the two radiator supports from the car body.
Detach the clamping straps from the radiator and
remove the engine hood
As from model 1971 (with headlight washer)
4. Remove the headlight decor fram
hoses for the headlight washers from the respective
nozzles. Disconnect the
unit only, the
earth cable from the battery.
opening it wide and then re-
Now
side. An assistant will hold
help to lift it off.
washer container and the
radiator
the
exchanger. Save the cool-
direction indicator
the car body.
Disconnect the
control wire.
es. Disconnect the
headlight cables.
5. a. Back off the four screws for the front panel
detach the two
body. Detach the clamping straps from the ra-
diatcr and
b. Bend the
backwards so that the headlight washer motor
goes clear.
0. Detach the
motor (note
cables).
the
REMOVAL OF FASTENING
6. Remove the
damaging the paintwork.
REMOVAL OF FRONT
radiator supports from
remove the control wire.
upper bracket on the expanSIon
cables from the headlight
the connection positions
SCREWS, FRONT PLATE
front panel, taking great care
PLATE
and
the car
.
tank
washer
of the
to avoid
A7n_ 1