Model - Saab 95 1967 Service Manual

REMUVAL AND
Removal of power unit
If the entire power unit is to
To lift out the engine only,

1,

Disconnect the battery
2_ Remove the hood by
moving the locking springs for the hood hinges
Disconnect the hose for the
Now grip the hinge stay,
wards to release the
will hold the hood on
lift it off.
Remove the water container and
headlight washer.
OF ENGINE HOOD
REMOVAL
3. Drain off the cooling
draining tap. To ensure that draining will be as ef-
fective as possible, bleed
bleed nipple on the heat exchanger. Save the cool-
ant
Up to and incl. model 1968:
4. Disconnect the headlight and direction
cables.
5- Back off the four screws for the front panel
detach the two radiator supports from the car .
hwy. Detach the clamping straps from the radiator
and remove the hood

Model

1969—1970:
4. Remove the headligh
the headlight cables.
5. Back off the four screws for
detach the two radiator support
body. Detach the clamping strap
tor and remove the control
4- Remove the headlight decor frames. Disconnec
the hoses for the headlight Washers frc|"'11h:r1ceables.
spective nozzles. Disconnect the head
INSTALLATION
be lifted out, see group 4
proceed as follows;
earth cable from
the battery.
opening it wide and then
windshield washer.
bending it slightly in-.
pin on one side. An assistant
the other side and help to
the pump of the
water through the radiator
the system through the
_ _
indicator
and
lock and control Wire.
t decor frames. Disconnect
the front panel and
s from the car
5 from the radia-
wire.
re-
'9
5- a. Back
detach
body.
diator
b. Bend
.
backwards, so that the headlight cleaner motor
goes clear.
re-
c. Detach
tor (note
REMOVAL OF FASTENING
6. Remove
damaging the paintwork.
OF
REMOVAL
t
SA"
off the four screws for the
the two radiator supports from the car
Detach the clamping straps from the ra-
and remove the control wire.
the upper bracket of the expansion
the cables from the headlight
the connection positions
SCREWS, FRONT
the front panel, taking great
FRONT PLATE
front panel and
tank
wiper mo-
of the cables).
PLATE
care to avoid
201—1