Model - Saab 95 1967 Service Manual

Changing headlight insert

1.

Open hood, pull out bulb connector.
2. Close hood, loosen decor frame screw, remove decor
frame.
3. Loosen the four screws which
Lift out headlight along with
4. Slacken the adjustment screws,
led out of the headlight
the insert from the mounting
Fitting is made in the reverse order.
NOTE
When changing headlight
the headlights.
Changing bulbs
A headlight bulb normally
hours of the burning time.
the light power decreases considerably after this time.
order to have as much light as possible,
visable to change the headlight
with normal driving.
Another factor of importance to effective
the reflector is undamaged
have good contact.
1. Open the hood and remove the
rubber sealing cap from the
2. Push in the bulb retainer
wise. The bulb can then be withdrawn.
3. Fit the new bulb. Do not touch the glass with
fingers. Make sure that the locating lug is correctly
positioned.
4. Fit the bulb retainer. Make sure that the spring
the bulb securely in its correct position.
5. Push on the connector.
ing cap, making sure that it fits snugly round the bulb
retainer and that the drain
IMPORTANT
If the bulb is incorrectly
faulty light pattern will result.
a
retain the headlight.
mounting plate.
until they can be PU"
insert attachments. Remove
plate.
insert or bulb, always align
has full power for the first 100
Even if the lamps work longer,
it is therefore ad-
bulbs about once a year,
lighting is that
and that the cable terminals
contact housing and
headlight.
and twist it counterclock-
your
locates
Fold down the edge of the seal-
hole is at the bottom.
located in the reflector, a
HEADLIGHT
CHANGING
Aligning right and left asymmetric beams
Headlight beams are normally adjusted with the help of
special apparatus, but can also be made against a marked
panel or a vall.
In
"b " 2.2th
,' :iii"
SCREWS FOR ADJUSTING

MODEL

1973
1. Screw for horizontal
2. Screw for vertical
1974
1. Screw for horizontal
2. Screw for vertical
m
BULB
'«_lll
'J/I'»""1 1';
'1'
HEADLIGHTS, UP TO
adjustment
adjustment
adjustment
adjustment
AND INCL.