Brake Pedal - Saab 95 1967 Service Manual

BRAKE OPERATION
UptoandincLInodel1968

BRAKE PEDAL

The brake pedal is carried on
pedal and is fitted with self-lubricating bushings.
STAND WITH PENDANT
PEDAL
1. Stop light switch
2. Brake warning contact
Removal and installation
1. Remove the steering column
2. Detach the fork for the
pedal.
3. Remove the cotter pins from both ends of the shaft.
the same shaft as the clutch
PEDALS
and gear shift shaft.
clutch cylinder from the clutch
4. Remove the clutch pedal
shaft.
5. Unscrew the master cylinder
nut.
6. Pull out the shaft leftwards and
al.
7. Check the bearing for wear
necessary.
Reinstall in the reverse order,
pedal free movement.
Adjustment
In order to ensure that the
will return fully every time the
there must always be a clearance
inder piston and the brake
al is at rest. This clearance,
aI, should be 0.12—0.24 in.
the push rod and the piston,
to 0.024—0.047 in. (0.6-1.2
c, / ,
In. II/////I/Il/I/1llllllllllll 'I/IM(l'
, ._ _. ,
like...
' ; u _— .. \
amvllmz/I/MI/n/I/t/IIJM/W .
f
ADJUSTMENT OF BRAKE PEDAL CLEARANCE
A =0.12—0.24 in. (3—6 mm)
Adjust as follows:
1. Back off the locking nut.
2. Turn the hexagonal part of the
rect clearance is obtained
3. Tighten the locking nut.
and return spring from the
od at the adjusting
push r
the brake
remove
ings if
and fit new bush
and then adjust the brake
piston in the master cylinder
brake pedal is released,
between the master cyl-
pedal push rod when the ped-
measured at the tip of the
(3—6 mm). Measured between
the clearance should amount
mm).
push rod until the cor-
at the tip of the pedal.
524—1
ped-
ped-