Model - Saab 95 1967 Service Manual

WIRING AND FUSES
WIRING
The cables and wires lead
generator to the various items of consumer equipment.
In order to protect the wiring
shorting, the wires are gathered
possible, i.e. a number of individually insulated wires are
carried in an enc|05ing plastic sheath.
The harnesses are divided
dash panel and in the engine compartment, and one
ning to the rear part of the car. Provided that the wiring
is fitted in strict accordance
grams reproduced further on,
wires and cables should not
individual wires and cables in each
ed for ready identification
ers given.
The cable connections are
and thus require no soldering.
Make sure that all cables and
thus avoiding unnecessary
Make sure that the wire from
so that it will not get torn
turned.
If frequent fuse burn out occurs,
tion is suspected, check the
by testing. Bear in mind, however, that fuses will not burn
out if a short occurs before
When installing new wiring, always check
the rating of the selected wires and
cope with the load involved,
are properly protected where
and at clamps.
FUSES
To protect wiring etc., from abnormal current
for instance in the event of a short circuit, and to reduce
the fire hazard involved by such occurrences, the electri-
cal system is provided with fuses,
tached to the R.H. side of the dash
compartment. In addition to the aforesaid fuses, there
a

3

amp. fuse for the headlamp
is located in a special holder.
One of the fuses are intended for the protection of extra
eQuipment or as reserve.
All the components included
cept the headlight (as from
IiSlhting and ignition system are fused. On the inside of
the fuse block cover is an identification text, showing
which items are protected by the individual fuses.
Febr um
the current from the battery or
and to reduce the risk of
into harnesses wherever
into two groups, one at the
run-
with the different wiring
removal and installation
present any difficulties. The
harness are color-mark-
in accordance with the numb-
made with AMP connectors
wires are properly connected,
voltage drops and flashovers.
the horn button is routed
off when the steering wheel
and if damaged insula-
insulation of the harnesses
the fuse.
positively that
cables is adequate to
and make sure that the cables
they pass through panels
intensities,
grouped in a block at-
panel in the engine
cleaning device. This fuse
in the electrical system ex-

model

1969), instrument
dia-
of
BLOCK
FUSE
is
FUSE BOX, HEAD
When fitting a
contact. If wire
is
fuse concerned
any further steps.
the maximum
LIGHT CLEANING DEVICE
IMPO RTANT
new fuse, take pains to secure good
fracture is suspected, check
makes good contact before taking
Use a voltmeter for this
permissible voltage drop is 0.1
that the
check:
V.
371-1