Start And Stop Of Components - NEC Express5800/R320c-E4 Maintenance Manual

Chapter 1 Maintenance
4.1

Start and Stop of Components

This section describes how to start or stop components.
If a component fails or needs to be replaced, the server allows you to forcibly stop the component. The stopped
component can also be restarted.
4.1.1 Available status
The table below shows the potential cases in which the dump is acquired.
Component
CPU module
PCI module
Important Use this feature to stop the relevant CPU module and PCI module before replacing
component.
Start
• Power supply stop
• Broken
• Forced stop
• Firmware Update Complete
• Diagnostics Passed
• Power supply stop
• Broken
• Forced stop
• Firmware Update Complete
• Diagnostics Passed
You can view the state of component by NEC ESMPRO Manager or ft Server Utility.
Tips
Express5800/R320c-E4, R320c-M4 Maintenance Guide (Linux)
State of component
Stop
• Duplex
• Duplex
4. Maintenance of the Server
27