NEC Express5800/R320c-E4 Maintenance Manual page 99

Chapter 2 Configuring and Upgrading the System
Command: 1 ------------------------------------------------------ (*3)
[List RAID Arrays]
Name
===============================================================================
< Mirroring Array (RAID1)
md0
md1
md2
md3
-------------------------------------------------------------- (*4)
Command action
1
2
3
4
5
6
7
8
c
q
Command: 1 ------------------------------------------------------ (*5)
[List RAID Arrays]
Name
===============================================================================
< Mirroring Array (RAID1)
md0
md1
md2
md3
*3 Check if the resynchronization process is started.
*4 Perform restoration (RECOVERY) to each RAID devices (md). After a while, check the Status with the command
listed below. "RESYNC" shows it is waiting to be restored. "R" on the left side of the Member indicates the disk
partition is either waiting to be restored or is in the process of restoring.)
*5 When each RAID device Status is DUPLEX, the RAID configuration is restored normally. This ends the disk
replacement procedure.
Partition (Label)
>
/boot ( - )
/var/crash ( - )
swap ( - )
/ ( - )
List RAID Arrays
List Internal Disks
Make Mirroring Arrays
Repair Mirroring Arrays (RAID1)
Delete Mirroring Arrays (RAID1)
Remove Disk Partitions
Make Striping Array
Delete Striping Array
Configurations
Quit
Partition (Label)
>
/boot ( - )
/var/crash ( - )
swap ( - )
/ ( - )
Express5800/R320c-E4, R320c-M4 Maintenance Guide (Linux)
Status
RECOVERY(73.2%)
RESYNC
RESYNC
RESYNC
(RAID1)
(RAID1)
(RAID1+0)
(RAID1+0)
Status
DUPLEX
DUPLEX
DUPLEX
DUPLEX
1. Disk Operations
Member
(1)sda1 R(9)sdi1
(1)sda2 R(9)sdi2
(1)sda3 R(9)sdi3
(1)sda5 R(9)sdi5
Member
(1)sda1 (9)sdi1
(1)sda2 (9)sdi2
(1)sda3 (9)sdi3
(1)sda5 (9)sdi5
99