Unpacking; Assembly; Symbols Used On The Equipment - ZOLL 731 Series Operator's Manual

G I
ENERAL NFORMATION

Unpacking

Carefully inspect each container for damage. If the shipping container or cushion material is
damaged, keep it until the contents have been checked for completeness and the instrument has
been checked for mechanical and electrical integrity. If the contents are incomplete, if there is
mechanical damage, or if the ventilator does not pass its electrical self-test, U.S.A. customers
should call ZOLL Medical Corporation (1-973-882-1212). Customers outside of the U.S.A.
should contact the nearest ZOLL authorized representative. If the shipping container is
damaged, also notify the carrier. If there is no apparent sign of mechanical damage, read
instructions contained within this manual before attempting operation.

Assembly

The unit only requires that the operator attach the breathing circuit to begin ventilation using
either internal or external power. Both the ventilator and breathing circuit are supplied clean
and are ready for use on a patient.
The unit's batteries may not be installed within the unit (depending on the contractual
requirements or the storage environment as described in the "Battery Care and Recharging"
section). Battery installation may be required prior to operation.

Symbols used on the Equipment

Any or all of the following symbols may be used in this manual or on this equipment.
Symbol
1-2
Description
Off
On
Direct Current: Identifies the location to connect external DC Power.
Mute / Cancel: Identifies button which mutes the active alarms or cancels
the parameter selection.
Accept / Confirm: Identifies button which accepts the parameter
selection.
ESD: Warns that connector pins should not be touched.
www.zoll.com 906-0731-01 Rev. J