Table of Contents
Advertisement
P
O
RODUCT
VERVIEW
limit is 40 b/min. To access the HR context menu, press and hold the HR parameter button.
The HR context menu provides control of the pulse oximeter settings.
Menu Item
Averaging
Sensitivity
Fast SAT
APOD
Signal Strength
Signal IQ
SpO2 -- Pressing the SpO2 button highlights the Low SpO
2.
value to be changed. The SpO
When no SpO
operator places the pulse oximeter in standby (stby) is displayed in the parameter window.
The default low SpO
3.
FIO
2
There are no adjustable secondary parameters. The default values at start up is 21% whether
oxygen is present or not. If an FIO
settings, the unit will start up with that saved FIO
If high-pressure oxygen is not present, the unit will start up with FIO
PRESSURE LOW alarm will not be activated. The secondary display in the parameter
window is O
support the patient at the current settings. O
a plus "+" sign next to the FIO
not include oxygen use in the O
1. O
Use = ((FIO
2
volume is the actual minute volume (controlled and spontaneous breaths * tidal volume).
2-10
Masimo Context Menu
Range
2-4, 4-6, 8, 10, 12, 14, 16 (t=sec)
Norm, Max
Off, On
Off, On
0 to 20
Bar graph
2
sensor is connected or if the probe is off the patient during start up or the
2
value at start up is 94%. SpO
2
-- Pressing the FIO
button highlights the current value and enables it to be changed.
2
1
Use
. This is the flow (liters/min) of high pressure oxygen used by the unit to
2
-0.21)/0.79)*Minute Volume where FIO
2
www.zoll.com
Description
Adjusts the SpO
Default: Norm, adjusts the pleth signal
sensitivity. Max is designed to interpret and
display data for even the weakest of signals.
This choice is recommended during procedures
and when clinician and patient contact is
continuous.
Default: Off, Fast SAT enables rapid tracking
of arterial oxygen saturation changes by
minimizing the averaging. This mode is
clinically applicable during procedures when
detecting rapid changes in SpO
such as induction, intubation, and sleep
studies.
Default: Off, When on, this mode improves
detection of the "probe off patient" condition,
but reduces the ability to acquire a reading on
patients of low perfusion.
Current signal strength value, not adjustable. A
value of zero indicates that no measurement is
available. This value helps clinicians place
sensors on optimal sites.
Bar graph displays the relative reliability of the
pulse oximeter signal.
display is active only when the pulse oximeter is connected.
uses the same Context Menu as HR.
2
value greater than 21% is saved and used for Power Up
2
value if high-pressure oxygen is present.
2
Reservoir mode is indicated on the display with
2
value when this mode is active. (The "O
2
Reservoir.)
2
is represented as a fraction and minute
2
and HR averaging durations
2
is paramount
2
Alarm Limit and enables its
2
= 21% and O
SUPPLY
2
2
Use" value does
2
906-0731-01 Rev. J
Advertisement
Table of Contents
