Typical Drives; Installations According To The European Electromagnetic Compatibility Directive; Conformal Installation - WEG CFW-11W G2 RB Series User Manual

Installation and Connection

3.4.11.4 Typical Drives

Drive 1 - Command via HMI (Local Mode) with General Enable function.
With the factory default setting, it is possible to operate the converter in the local mode. This operating mode is
recommended for users that are using the converter for the first time, as a form of learning.
To start in this operating mode, follow the directions available in
page 5-1
The DI1 is already programmed to General Enable as a factory default setting (P0263 = 2).
3
3.5 INSTALLATIONS ACCORDING TO THE EUROPEAN ELECTROMAGNETIC
COMPATIBILITY DIRECTIVE
The CFW-11M G2 RB and CFW-11W G2 RB converters, when correctly installed, meet the requirements of the
EMC Directive 2004/108/EC.
The CFW-11M G2 RB and CFW-11W G2 RB converters were developed for professional applications only. Therefore,
the limits for emission of harmonic currents established by the EN 61000-3-2 and EN 61000-3-2/A14 standards
are not applicable.

3.5.1 Conformal Installation

For conformal installation, use:
Standard CFW-11M G2 RB and CFW-11W G2 RB converter for emission levels according to IEC/EN61800-3
„
"Adjustable Speed Electrical Power Drive Systems", category C4.
3-50 | CFW-11MW G2 RB
7
8
9
10
11
12
13
General
14
Enable
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
Figure 3.61: Connections in XC1 for drive 1
Chapter 5 ENERGIZATION AND START-UP on
Conector XC1
AO1
AGND (24 V)
AO2
AGND (24 V)
DGND*
COM
24 Vcc
COM
DI1
DI2
DI3
DI4
DI5
DI6
NF1
DO1
C1
(RL1)
NA1
NF2
DO2
C2
(RL2)
NA2
NF3
DO3
C3
(RL3)
NA3