Ricoh 2105 Operating Instructions Manual page 44

Printer/scanner unit
Hide thumbs Also See for 2105:
Table of Contents

Advertisement

Setting Originals
Top to top
original:
Top to bot-
tom original:
Note
❒ When the last page of two-
sided originals is blank, se-
3
lect [1 Side] to skip that side
and finish scanning, or select
[2 Sides] to scan that side as a
blank page.
❒ If [1 Side] is selected for the
last page when scanning
originals in several batches,
the maximum number of
pages per file may decrease
depending on the number of
batches set.
❒ If [1 Side] is selected for the
last page, the image size
might become larger than
original and may exceed the
maximum e-mail size possi-
ble. In this case, change the
settings of [Max. E-mail Size] in
scanner settings. See p.11
"Initial Scanner Setup".
❒ When scanning originals on
the exposure glass with the [2
Side Orig.] setting, set [1 Side]
for the last original.
C Press [OK].
Original feed type selection
A Press [Original Feed Type].
B When scanning a large number
of originals using the ADF by
dividing the originals and
scanning them individually or
in batches, check that [SADF] or
[Batch] is selected.
38
R S
R S
R
R
S
S
Note
❒ Select [SADF] for adding orig-
inals one by one, or select
[Batch] for adding the origi-
nals in batches.
❒ Select whether [SADF] or
[Batch] is displayed using the
initial scanner setting [Origi-
nal Feed Type Priority].
C Press [Mix 1&2 Sided] to beable
to switch between [1 Side Orig.]
and [2 Side Orig.] while scan-
ning originals.
Note
❒ When either [SADF] or [Batch]
is not selected, [Mix 1&2 Sided]
cannot be selected.
❒ When [Mix 1&2 Sided] is select-
ed, the scanning mode can be
switched by selecting [1 Side
Orig.] or [2 Side Orig.] while
the countdown until origi-
nals are no longer accepted is
progressing. You cannot
switch to or from [1 Side Orig.]
and [2 Side Orig.] until the
scanning of one original is
completed.
❒ One-sided
and
originals are usually output
to different trays but when
[Mix 1&2 Sided] is selected, all
originals are output to the
same tray reversed (back
side facing up) regardless of
whether they are one-sided
o r t w o - s i d e d o r i g i n a l s .
Avoid using originals that
are unsuitable for the ADF
such as thick paper.
D Press [OK].
two-sided

Advertisement

Table of Contents
loading

Table of Contents