Table of Contents
Advertisement
AT commands
Parameter
1
2
3
4
5
6
Default
0
P3 (DIO13/DOUT)
Sets or displays the DIO13/DOUT configuration (pin 3).
Parameter range
0, 1
Parameter
0
1
Default
1
P4 (DIO14/DIN)
Sets or displays the DIO14/DIN/CONFIG configuration (pin 4).
Sets or displays the DIO14/DIN configuration (pin 4).
The device enters Command mode at 9600 baud if you enable DIN and either of the following
conditions is met:
A six second serial break is received during normal operation.
n
DIN is driven low upon power up or reset.
n
The device sends an OK response out of the UART when it enters Command mode in this way.
Parameter range
0 - 1
Parameter
0
1
XBee®/XBee-PRO SX RF Module User Guide
Description
N/A
N/A
Digital input
Digital output, low
Digital output, high
RX LED
Description
Disabled
UART DOUT enabled
Description
Disabled
UART DIN/CONFIG enabled
I/O settings commands
91
Advertisement
Table of Contents
