Monitoring Alarms And Troubleshooting - Dekolink Deko3108S Product Manual

P M
RODUCT ANUAL
5.3 M
ONITORING
This section provides alarm descriptions and troubleshooting procedures.
To display the Repeater Alarms
• From the Tree Pane, Select Deko3108, and click the Alarms tab.
Resets all alarms
NOTE: The Panel Switch Mask is RED by default indicating that the Panel Switch
Mask parameter in the Config and Params tab (section 4.3) is set to ON. This does
NOT indicate an error. (If the Panel Switch Mask parameter is set to OFF, the
corresponding indicator in the Alarms tab will be GREEN).
• To reset the alarms, click Ack All.
The following table provides a description of the alarms displayed in the Alarms screen.
Alarm
Power Above Threshold
PAmp Current
Channeler Current
RSSI
PLL Lock Detect
Page 40
C R
OMPACT EPEATER
A T
LARMS AND ROUBLESHOOTING
Description and probable cause
Malfunction in the Downlink path
– caused by the output power
being less than the minimum
threshold limit
Malfunction in UL/DL path because
of low current outputs from the
power amplifier
Malfunction in UL/DL path because
of low current outputs from the
channeler
Malfunction in UL/DL path caused
by a excessively high input signal
Malfunction in UL/DL path caused
Proprietary Data
D 3108S D
EKO EKOLINK
Recommendation
Check the Max Power Value in
the Controls and Parameters.
Check the Repeater LEDs. 1.4.3
Check the Repeater LEDs. 1.4.3
Check the Repeater LEDs. 1.4.3
Check the Repeater LEDs. 1.4.3
W L .
IRELESS TD
RED by default
(Panel Mask
switch is set to
ON).
P/N 300XC10031 Rev. B