Power Up; Antennas Installation And Connections - Dekolink Deko3108S Product Manual

D W L .
EKOLINK IRELESS TD
3.6 P U
OWER P
NOTE: See section 2.1 for power-supply requirements.
To power-up
The Repeater operates from a 100 to 240 VAC Mains. The maximum consumption
power is 150W (typical).
Connect the AC power cable to the Repeaters front panel 100-240VAC connector.
3.7 A I
NTENNAS NSTALLATION AND
3.7.1 Antenna Installation Requirements
3.7.1.1 Base (Donor) Antenna
NOTE: Verify that the antennas meet requirements described in section 2.3.1.
Installation requirements:
• The antenna should point to the direction of the base station for maximum input
power
• Verify that the antenna is in the base stations line of sight (raise the antenna if
necessary)
• Install the donor antenna at a higher level (i.e. floor) than the mobile antenna
• Must be installed at a minimum distance of 1 meter from any personnel within the
area.
3.7.1.2 Mobile (Service) Antenna
NOTE: Verify that the antennas meet requirements described in section 2.3.2.
Installation requirements:
• Install the service antenna on the ceiling or on the wall so it would shadow the
required coverage area within the in building environment.
• Installation of this antenna must provide a minimum separation distance of 0.2 m
from any personnel within the area.
• Cable and jumper loss is at least 2dB.
P/N 300XC10031 Rev. B
D 3108S M R
EKO IDI EPEATER
WARNING: Do not unscrew
Figure 3-8. Power Up Connection
C
ONNECTIONS
Proprietary Data
while power is connected
P M
RODUCT ANUAL
100-240VAC
Page 23